Trade services
Full mechanical, electrical, and plumbing scopes for projects run by other contractors, from design coordination through final testing, and everything in between.
HVAC install, replacement, and service. Trade contractor on jobs run by other GCs. Miami-Dade, Broward, Palm Beach, Collier, Lee counties.
Load calculations, equipment schedules, and submittal review against the mechanical drawings, covering tonnage, static pressure, and electrical characteristics for each unit.
Supply and return ductwork, diffusers, registers, and balancing dampers, sized and routed to the mechanical drawings.
Packaged rooftop units, split systems, curbs, and roof penetrations, set and connected with refrigerant piping, condensate drainage, and electrical terminations.
Thermostats, sensors, and control wiring, with startup, air balancing, and functional testing recorded on commissioning reports.
Filter changes, coil cleaning, refrigerant checks, and belt replacement on a scheduled interval, with response times set by the agreement.
Panel upgrades, tenant build-out wiring, lighting installation. Code-compliant, coordinated with other trades on site.
Conduit, boxes, and branch circuit wiring at rough in, then devices, plates, and fixture connections at finish, terminated and tested.
Service entrance, meter stacks, panelboards, and feeders, with load calculations, breaker schedules, and the utility application for the new service.
Branch circuits, receptacles, dedicated equipment circuits, and lighting for tenant spaces, set out to the approved fit out drawings.
Fixture counts, mounting heights, switching zones, and dimming controls coordinated against the reflected ceiling plan.
Fire alarm devices, exit and emergency lighting, and pathways for data, security, and audio visual, coordinated across the relevant permits.
New installation, repiping, fixture work. Commercial plumbing for build-outs and new construction.
Under slab waste and vent piping, sleeves, and stub ups set to the plumbing drawings, then pressure tested and inspected.
Water closets, lavatories, sinks, trim, and stops set and connected, with carriers, escutcheons, and final leak checks.
Domestic hot and cold water distribution, waste and vent risers, cleanouts, insulation, and hangers throughout the building.
Natural gas and propane piping, regulators, shutoff valves, and appliance connections, pressure tested and certified.
Reduced pressure and double check assemblies, strainers, and test ports, installed and certified with reports issued to the authority having jurisdiction.